Peugeot 308 Key Fob Replacement
Peugeot's 308 is a little old, but it is still attractive. It's not the most luxurious vehicle in its class, but it is a relaxing and civilised driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. If the issue is persistent or intermittent, the following tips should help.
Water Damage
If you accidentally drop your key fob into the puddle, or it is soaked while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry, dry bag each time you are outdoors or engage in things that expose it to large amounts of water.
It's also important to make sure that the fob is completely dried out before you open the fob and then use it. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid) it is a indication that it's submerged.
A circuit board that is wet could cause the battery to discharge its charge, or even explode. If you're able, if you can, pull your 308 key fob out of the water body it was stuck in, flip the button side down and shake it out as much water as you can before opening the case. After you open it, remove the battery and clean the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system may stop working include the battery of your coin is dead problems with the receiver module, signal interference, or an electronic chip that is damaged. If none of the above are the issue you can reset the system by removing the 12 Volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with remote start technology that allows drivers to start their vehicle from some distance, which allows them to warm up or cool down the car before they enter. This feature is extremely useful, especially during winter's cold and chilly months. The remote start system may cease to function for a variety reasons, such as the dead battery in the coin-battery.
A coin-shaped battery that is in the key fob will last a time of two to four years, depending on how frequently it is used and the location where it was purchased. The date of use is printed on the packaging or in the user manual.
If the key fob is no longer working after being exposed to clean tapwater, take out the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. If you expose it to salty or soapy water, the chip may be fried and you will require replacing the key fob completely.
If you're not certain the battery is in good condition it is possible to test its voltage using an instrument set to the car's voltage range. Connect it to the terminals for minus and plus. The voltage should be around 12 to 13 volts, but if it's lower, the battery must be replaced. You can also reset your computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). peugeot key replacement should start after this.
Faulty Receiver Module
If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has been afflicted with a fault. It's the component that sends an alarm to the car when your key fob is activated which also acts as an immobiliser, and stops it from starting unless the correct key is present.
The cause could be various reasons, such as water damage or simply ageing. If your Peugeot 308 key fob has been exposed dirty tap water, like the electronic chip located inside is damaged. In this instance, you'll need to take the unit apart and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once it's dry you can put the battery back in and try it again.
If the issue persists you're probably in need of a idea to seek out a local Peugeot specialist or locksmith. They'll be able utilize a diagnostic tool to identify the problem and fix it.
It can be stressful to lose your Peugeot car key. However, a trained auto locksmith can solve the issue in just a few minutes. They can cut a brand new key and then program it into your vehicle, ensuring that you're ready to get out on the road in the shortest amount of time. Click here to find locksmiths near you.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is an important component of the remote control system. If it is damaged, your car may not start or receive a message stating "anti-theft active". In this situation the only option is to replace the key. Professional auto locksmiths are able to provide this service within the shortest possible time.
The chip in the chip of your Peugeot 308 key fob can fail due to water damage, sweat dirt, or other causes. If your Peugeot key fob has been exposed soapy or dirty water, it must be cleaned right away. You can employ a paper towel as well as isopropyl alcohol to clean the electronic component. The battery should be allowed to completely dry.
Sometimes the key fob may stop working because of radio interference. This can be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity of the vehicle. If you experience this issue you should visit a Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and needs particular care. It should not be dropped or throw it around. If you lose it, try to find it as quickly as possible. You can reset the on-board computer by disconnecting the battery for a few minutes. Disconnect the negative cable prior to the positive.